Ram 1500/2500/3500: Soft-Keys
Soft-Keys are accessible on the Uconnect display.
Customer Programmable Features - Uconnect
5.0/8.4 Settings
Uconnect 5.0 - Press the SETTINGS hard-key to display
the menu setting screen. Uconnect 8.4-Touch the
"Apps" soft-key, then touch the "Settings" soft-key to
display the menu setting screen. In this mode the
Uconnect system allows you to access programmable
features that may be equipped such as Display, Clock,
Safety/Assistance, Lights, Doors & Locks, Auto-On Comfort & Remote Start, Engine
Off Operation, Compass
Settings, Audio, Phone/Bluetooth and SiriusXM Setup.
NOTE: Only one touchscreen area may be selected at a
time.
When making a selection, touch the soft-key to enter the
desired mode. Once in the desired mode, touch and
release the preferred setting until a check-mark appears
next to the setting, showing that setting has been selected.
Once the setting is complete, either touch the back
arrow soft-key or the Back hard-key to return to the
previous menu or touch the "X" soft-key to close out of
the settings screen. Touching the Up or Down Arrow
soft-keys on the right side of the screen will allow you to
toggle up or down through the available settings.
READ NEXT:
After pressing the "Display" soft-key the following settings
will be available.
Display Mode
When in this display you may select one of the auto
display settings. To change Mode status, touch and
r
After pressing the "Safety & Driving Assistance" soft-key
the following settings will be available.
Park Assist
The Rear Park Assist system will scan for objects behind
the vehicle when the tra
After pressing the Lights soft-key the following settings
will be available.
Headlight Off Delay
When this feature is selected, the driver can choose to
have the headlights remain on for 0, 30, 60,
SEE MORE:
Hard-Keys are located below the Uconnect system in
the center of the instrument panel. In addition, there is a
Scroll/Enter control knob located on the right side of the
Climate Controls in the center of the instrument panel.
Turn the control knob to scroll through menus and
change settings (i.e.,
NOTE: To create a new memory profile, perform the
following:
Vehicles Equipped With Keyless Enter-N-Go
1. Without pressing the brake pedal, push the ENGINE
START/STOP button and cycle the ignition to the
ON/RUN position (do not start the engine).
2. Adjust all memory profile settings to desired pre