Ram 1500/2500/3500: Mega Cab Rear Seat Features
Reclining Rear Seats - If Equipped
The recliner handle is located on the outside of the seat cushion. To adjust the seatback, lift upward on the handle, lean back on the seatback and when you reach the desired position, release the handle.
.png)
Rear Seat Recliner Handle
WARNING! Do not ride with the seatback reclined so that the shoulder belt is no longer resting against your chest.
In a collision you could slide under the seat belt, which could result in serious injury or death.
Folding Rear Seat (Table Mode) - If Equipped
Both the left and right rear seatbacks can be folded down and used as a table.
To fold down either rear seatback:
1. Lift the handle, located next to the head restraint.
.png)
Table Mode Handle
2. Fold the seatback forward.
.png)
Table Mode
3. Lift the seatback, to return the seat to the upright position. Be sure the seatback is locked in place.
Folding Rear Seat - If Equipped
Both the outboard rear seats will drop and move forward when the seatback is folded flat.
WARNING!
- It is dangerous to ride in a cargo area, inside or outside of a vehicle. In a collision, people riding in these areas are more likely to be seriously injured or killed.
- Do not allow people to ride in any area of your vehicle that is not equipped with seats and seat belts.
- Be sure everyone in your vehicle is in a seat and using a seat belt properly.
- Cargo must be securely tied down before driving your vehicle. Improperly secured cargo can fly around in a sudden stop or collision and strike someone in the vehicle, causing serious injury or death.
To fold either rear seat flat:
1. Lift the handle, located on the outboard side of either of the rear seats.
.png)
Folding Rear Seat Handle
2. Fold the seatback down and push the seat forward.
.png)
Rear Passenger Fold-Flat Seats
3. Lift the seatback, to return the seat to the upright position. Be sure the seat is locked in place.
WARNING! An improperly latched seat could cause serious injury or death. Make sure that the seatback is securely locked into position. If the seatback in not securely locked into position the seat will not provide the proper stability for child seats and/or passengers.
READ NEXT:
Head Restraints
Head restraints are designed to reduce the risk of injury
by restricting head movement in the event of a rear
impact. Head restraints should be adjusted so that the top of the head restraint
is locat
Driver Memory Seat - If Equipped
This feature allows the driver to store up to two different
memory profiles for easy recall through a memory
switch. Each memory profile contains desired position
settings for the driver seat, side mi
Programming The Memory Feature
NOTE: To create a new memory profile, perform the
following:
Vehicles Equipped With Keyless Enter-N-Go
1. Without pressing the brake pedal, push the ENGINE
START/STOP button and cycle the ignition to
SEE MORE:
Jack Instructions (1500 Series)
WARNING!
Carefully follow these tire changing warnings to
help prevent personal injury or damage to your
vehicle:
Always park on a firm, level surface as far from the
edge of the roadway as possible before raising the
vehicle.
Turn on the Hazard Warning flasher.
Block the wheel diagonally oppo
Department Of Transportation Uniform Tire Quality Grades
The following tire grading categories were established by
the National Highway Traffic Safety Administration. The
specific grade rating assigned by the tire's manufacturer
in each category is shown on the sidewall of the tires on
your vehicle.
All passenger car tires must conform to Federal safety
